Comments on: How To Regrip A Golf Club In Under 4 Minutes

By: Adam

Adam — Mon, 06 Feb 2012 18:21:27 +0000

One of the most useful youtube videos I have seen. I now almost have the guts to try it myself….almost.

By: John Duval

John Duval — Thu, 11 Aug 2011 02:13:39 +0000

I’m sure there are some good videos on YouTube about installing a shaft. Perhaps I should tackle that project and post a video of my own. I don’t do too much re-shafting because I don’t have all the “proper” tools, but I’m sure I can put something together…

By: mitch

mitch — Wed, 10 Aug 2011 21:20:58 +0000

PS – I used glue-clamps and a hunk of 3/4″ plywood on top of our glass-topped backyard patio table instead of a vice on a bench. Worked fine. Ready to take on installing iron shafts – know of a good instructional video or website?

By: mitch

mitch — Wed, 10 Aug 2011 21:12:31 +0000

Did 11 clubs last night. Took the time needed to drink two beers, working between sips. Played 5 holes with them early today, b4 work and they are good as any I’ve paid to have done. Thank you!

By: Bob

Bob — Fri, 22 Apr 2011 01:54:34 +0000

Good how-to John!
Instead of putting my finger over the grip hole, I stick a tee in the hole then fill the grip with solvent.

By: John Duval

John Duval — Sun, 17 Apr 2011 02:56:18 +0000

No secret. Just slide it on at an angle and the solvent should help it along. Most grips come in either .580 or .600 diameter, so obviously the .600 inside diameter grips will probably slip on easier…

By: david a geiss

david a geiss — Sat, 16 Apr 2011 23:24:08 +0000

question– what’s the secret of opening up the new grips end enough to slide it over the shaft of the club? heating it??

By: Ron Cooney

Ron Cooney — Wed, 05 May 2010 22:47:47 +0000

Good how-to. Here’s a tip to
help remove backing of the
double-sided tape: simply fold
one corner of the tape strip
before placing it on the shaft.
Place strip on shaft, then pick
with your fingernail at the folded
corner; backing should come away
easily. Then zip — off comes the
rest.

By: jamie

jamie — Sun, 04 Apr 2010 23:38:36 +0000

WOW— this was easy.
i didnt use a clamp, just bare handed it and did all 12 clubs in 35 minutes…….
used lighter fluid and double sided tape ….great video !!!
jamie–canada golfer

By: John Duval

John Duval — Tue, 02 Mar 2010 14:19:09 +0000

For steel shafts I use the tape remover tool from Golfsmith, and it even works well for graphite shafts as long as you are careful. You can also do it the old fashioned way – with your fingers and a bit of patience! If I had taken the time to remove the grip tape in that video, it would have been named “How to Regrip A Golf Club in 10 Minutes”